Technician Class
Entry-level amateur radio license exam covering basic regulations, operating practices, and electronics fundamentals. 35 questions, 26 needed to pass.
How are the transceiver audio input and output connected in a station configured to operate using FT8?
Where should an RF power meter be installed?
What signals are used in a computer-radio interface for digital mode operation?
Which of the following connections is made between a computer and a transceiver to use computer software when operating digital modes?
Which of the following conductors is preferred for bonding at RF?
How can you determine the length of time that equipment can be powered from a battery?
What function is performed with a transceiver and a digital mode hot spot?
Where should the negative power return of a mobile transceiver be connected in a vehicle?
What is an electronic keyer?
What is the effect of excessive microphone gain on SSB transmissions?
Which of the following can be used to enter a transceiver’s operating frequency?
How is squelch adjusted so that a weak FM signal can be heard?
What is a way to enable quick access to a favorite frequency or channel on your transceiver?
What does the scanning function of an FM transceiver do?
Which of the following controls could be used if the voice pitch of a single-sideband signal returning to your CQ call seems too high or low?
What does a DMR “code plug” contain?
What is the advantage of having multiple receive bandwidth choices on a multimode transceiver?
How is a specific group of stations selected on a digital voice transceiver?
Which of the following receiver filter bandwidths provides the best signal-to-noise ratio for SSB reception?
Which of the following must be programmed into a D-STAR digital transceiver before transmitting?
HAM Test Bank Editorial Team
Licensed Amateur Radio Operators & Volunteer Examiners
Content for Technician Class exam questions is based on official FCC Part 97 regulations and the NCVEC question pool.